Nissan primera P12 F9Q oil pan removal |
Post Reply |
Author | |
petterg
NPOC Guest Joined: 01 Jun 2014 Location: Norway Online Status: Points: 396 |
Post Options
Thanks(0)
Posted: 02 Dec 2017 at 4:40pm |
Nissan Primera P12 2004 (post facelift) 1.9dci (F9Q) 6 speed manual
I have a oil leak between the oil pan and engine. Does anyone know if I need to remove the gearbox/clutch housing from engine in order to get the oil pan off? |
|
p11primeragt
NPOC Guest Joined: 29 Jul 2011 Online Status: Points: 18750 |
Post Options
Thanks(0)
|
Are you sure it's from the sump itself or it could be the rear main crank seal?
|
|
timeshock!
NPOC Guest Joined: 29 Jan 2006 Location: Newcastle Online Status: Points: 14483 |
Post Options
Thanks(0)
|
If it is the pan this is taken from the ESM for your engine CAUTION:
To avoid the danger of being scalded, never drain the engine oil when the engine is hot. REMOVAL 1. Remove engine undercover. 2. Remove RH front wheel. 3. Remove right side splash cover. 4. Remove front drive shaft assembly RH side. Refer to FAX-11, "FRONT DRIVE SHAFT" .5. Remove rear torque rod mounting bolt as shown. 6. Drain engine oil. Refer to LU-16, "Changing Engine Oil" .CAUTION: Perform when engine is cold. MBIB0951E 1. Baffle plate 2. Gasket 3. Oil pan 4. O-ring 5. Drain plug 6. Oil level gauge (with oil filer cap) 7. Crankshaft position sensor MBIB0952E OIL PAN EM-151 [F9Q] C D E F G H I J K L M A EM 7. Remove oil pan and transaxle joint bolts. 8. Support the engine bottom of the oil pan with a transmission jack etc. 9. Remove oil pan bolts in the reverse order as shown. l Insert seal cutter (special service tool) between oil pan andcylinder block. Slide tool by tapping on the side of the tool with a hammer. CAUTION: Exercise care not to damage mating surface. 10. Remove oil pan. MBIB0953E MBIB0954E MBIB0820E SEM365EA EM-152 [F9Q] OIL PAN 11. Remove baffle plate mounting bolt, then remove baffle plate. INSPECTION AFTER REMOVAL Clean oil pump assembly if any object attached. INSTALLATION l Install in the reverse order of removal paying attention to the following.1. Install baffle plate. 2. Apply liquid gasket as shown. l Use Genuine Liquid Gasket or equivalent.3. Install oil pan bolts in the numerical order as shown. 4. At least 30 minutes after oil pan is installed, pour engine oil. INSPECTION AFTER INSTALLATION l Inspection the engine oil level. Refer to LU-16, "ENGINE OIL" .l Start the engine, and make sure there is no leak of engine oil. Refer to LU-16, "ENGINE OIL" . |
|
Post Reply | |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |