Nissan Primera P11 ABS(?) problem |
Post Reply | Page <123 |
Author | |
Ryoko
NPOC Guest Joined: 26 Mar 2017 Online Status: Points: 23 |
Post Options
Thanks(0)
|
Oh, I'm sorry, I didn't mention in the previous comment: yes, it comes on when I switch the ignition on. |
|
d60_tag
NPOC Guest Joined: 18 Jul 2015 Online Status: Points: 533 |
Post Options
Thanks(1)
|
Strange- have you tried the ABS Diags (short out pin4 to earth on Consult connector)?
it may show something- even though the warning light doesn;t seem to show... worth a try.... http://www.npoc.co.uk/forum/p11-abs-system-diagnostic_topic48583.html Also for the fact that BOTH the rear sensors have similar wrong readings suggests that it maybe some sort of feed problem? I may expect ONE of either of the sensors to have been faulty but is strange how they BOTH are showing same sort of wrong readings- I may start to think the rear sensors may actually be okay and it could be some sort of feed/ supply issue to the sensors ? Also there are relays for the ABS system seem to remember in the engine bay- check those out also.. I may start to think is a wiring/ feed issue maybe to the rear sensors, rather than the actual rear sensors themselves... |
|
d60_tag
NPOC Guest Joined: 18 Jul 2015 Online Status: Points: 533 |
Post Options
Thanks(1)
|
- actually - thinking more- maybe the rear sensors have BOTH gone bad- for whatever reasons.. not sure...
again you may more expect ONE of them to have gone bad but maybe not both- there again, maybe BOTH have gone bad for whatever reasons- guess you may have to swap them for some good ones and see what happens- hope new ones don't go bad also.. in case some other factor like feed is causing them to blow out... would defo give the diags a shot also... |
|
Ryoko
NPOC Guest Joined: 26 Mar 2017 Online Status: Points: 23 |
Post Options
Thanks(0)
|
I'm sorry for the late reply. I was extremely busy recently.
When I measured the resistance, there was a problem with the connection of the dvom. I was very tired that day, so I didn't notice that. About 2 days later, I measured the resistance again. ~1,6xx kOhm at all wheels. I noticed that the ABS ring was quite rusty at the left front wheel, I tried to remove the dust - as much I as could. Since then I haven't experienced the problem. Thank you very much for all the answers! |
|
Post Reply | Page <123 |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |