Nissan Primera P11-144 stalling at idle |
Post Reply | Page <1 6789> |
Author | |
nunofos
NPOC Guest Joined: 03 Oct 2017 Online Status: Points: 6 |
Post Options
Thanks(0)
|
Sorry for bringing up the post, but I have que same problem.
My car, a P11-144 1.8 has a annoying problem, at cold starts if I don't rev up, the rpm drops and stalls. It went to a garage and they change the MAF sensor for an original Bosch one, the first day all ok, no problem at cranking or idleling, but the next day the problem started again, as well the engine light. Anyone know what could be the problem? Also, could the shop put the wrong MAF? I searched and I found a lot of Bosch sensors, they installed this one: 0 280 218 094, is the correct one? Anyone can confirm? |
|
gaz1234
Play Nice Group (N) Joined: 20 Jul 2012 Location: Som Online Status: Points: 60 |
Post Options
Thanks(0)
|
Yep mine was the maf from memory
|
|
imckay
NPOC Member Joined: 11 Mar 2007 Location: Manchester Online Status: Points: 3374 |
Post Options
Thanks(0)
|
Welcome to NPOC.
Your problems sounds more like an Idle Air Control Valve. A faulty MAF normally causes stalling or nearly stalling when slowing down for junctions once the Car is warm. What Year is your Car? There are 2 different MAFs. They are the same but one has an Air Intake Temperature Sensor. If you need the Temp Sensor (5 Wires going to the MAF Connector) and it doesn't have one you will get a P0110 Error. It shouldn't affect how the Car runs though. It can also take a few days for the Car to adapt to a new MAF but you shouldn't be getting stalling from a cold start. You could try disconnecting the Battery for 30 Mins. |
|
nunofos
NPOC Guest Joined: 03 Oct 2017 Online Status: Points: 6 |
Post Options
Thanks(0)
|
The first problem I encounter (before changing the MAF) was that in idle the car revs go up and down by itself, sometimes don't even started if I didn't revved, the moment I stopted the car stalled. Then they changed the MAF, no problem, no lights.
The next day, I encounter all the problems I said above. And yes, when I reduce to go in a junction the revs drops so much the car almost stalls and vibrate. It's from 2002.
|
|
nunofos
NPOC Guest Joined: 03 Oct 2017 Online Status: Points: 6 |
Post Options
Thanks(0)
|
Sorry for the double post, I can't edit.
I also hear a little whistle in idle (if I rev the noise disappears) that I didn't hear before all these problems. Tomorrow I will try the diagnostic to see what error the car gives.
|
|
p11primeragt
NPOC Guest Joined: 29 Jul 2011 Online Status: Points: 18750 |
Post Options
Thanks(0)
|
You have a gasket/hose air leak.
|
|
nunofos
NPOC Guest Joined: 03 Oct 2017 Online Status: Points: 6 |
Post Options
Thanks(0)
|
Update: I tried to make the diagnostic but with no success. I follow the procedure in this topic(http://www.npoc.co.uk/forum/topic8946.html), but the light doesn't blink.
I also record this video: https://www.youtube.com/watch?v=u0MWUvbEGsM I need to refer that all the problems started in one day. I stopped the car for about 2 months, it crank first time and for a few days no problems at all, one day it makes all that problems. |
|
imckay
NPOC Member Joined: 11 Mar 2007 Location: Manchester Online Status: Points: 3374 |
Post Options
Thanks(1)
|
The diagnostic only works on the early P11-144
You can get a Bluetooth OBD2 Adapter that will work with Android and iPhone quite cheaply. Less than 10 Euro Or a plug in OBD2 reader for a bit more 20-30 Euro It is not easy to see if the bad running is due to a misfire or the low idle speed. You can relearn the Idle Speed Service Manual http://www.npoc.co.uk/forum/nissan-primera-factory-service-manuals_topic29493.html P11-144.rar Get Winrar to unpack it. See Chapter EC QG16 and QG18. Page 34 (Without Consult) Warm the Car up fully Turn everything Electrical off. Lights, Radio and Fan Unplug and Replug Throttle Position Sensor within 5 Seconds Nissan Connector Removal. Awkward if you don't know https://www.youtube.com/watch?v=a5chL4I8oyU Presume you are in Germany from the MAF Link? Which looks like the right one by the way.
|
|
nunofos
NPOC Guest Joined: 03 Oct 2017 Online Status: Points: 6 |
Post Options
Thanks(0)
|
Oh, so that's the problem.. I tried an electrical wire, a paper clip nothing worked About que car and MAF, yes, I currently live in Germany, and i'm relief that the mechanic installed the correct one.
|
|
nunofos
NPOC Guest Joined: 03 Oct 2017 Online Status: Points: 6 |
Post Options
Thanks(0)
|
Update: I tried relearn the Idle Speed as imckay said, no luck. The problem continues, I also removed and cleaned the PCV valve just in case, no changes.
|
|
Post Reply | Page <1 6789> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |