nissan primera p12 1.8 cutting out |
Post Reply |
Author | |
oscarsaudio
NPOC Guest Joined: 15 Oct 2018 Location: essex Online Status: Points: 5 |
Post Options
Thanks(0)
Posted: 15 Oct 2018 at 3:27pm |
Hi ,
Hoping for some help , recently acquired a 2006 1.8 flare . Test drive and drive home were fine . Now she starts but instantly cuts out even if I try and rev her to keep her going . I'm thinking possible fuel related ? has anyone had the same issue ? thank in advance for your help
|
|
p11primeragt
NPOC Guest Joined: 29 Jul 2011 Online Status: Points: 18750 |
Post Options
Thanks(1)
|
Normally either the maf or the cam chain given the engine.
|
|
oscarsaudio
NPOC Guest Joined: 15 Oct 2018 Location: essex Online Status: Points: 5 |
Post Options
Thanks(0)
|
Cam chain is my worry as I presume they are a big job and probably not cost effective .
Will these cars start with the maf disconnected ( to help rule this out ) ? |
|
p11primeragt
NPOC Guest Joined: 29 Jul 2011 Online Status: Points: 18750 |
Post Options
Thanks(1)
|
Yes it will.You might need to hold it on the gas though for a few seconds then it should idle without any input.
Will start to run rich but not a problem as a test only. |
|
oscarsaudio
NPOC Guest Joined: 15 Oct 2018 Location: essex Online Status: Points: 5 |
Post Options
Thanks(0)
|
Well pulled the pipe off the back of the maf no difference but when put back on she started but the idle speed was 1500 revs this was for about a minute before cutting out again .
|
|
Post Reply | |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |