Nissan Primera P11 144 amp power cable |
Post Reply | Page 12> |
Author | |
jonnyw
NPOC Guest Joined: 11 Oct 2008 Location: Lancashire Online Status: Points: 56 |
Post Options
Thanks(0)
Posted: 11 Oct 2008 at 1:42pm |
I hoep someone can help.
was wondering if anyone knew an easy way to get the power cable (for an amp) from the battery into the cabin of my Nissan Primera P11/144? I'd really prefer not to drill, because when I did this on my Punto previously, the drill bit going into the engine bay went through a 4 mm gap between 2 brake pipes! (so I certainly don't want to risk anything like that). Similarly, does anyone have any hints/tips about routing the cables through the car to the boot (with as little showing as possible)? Cheers |
|
Nissan Primera P11/144 Sport
|
|
Baz007
NPOC Guest Joined: 15 Mar 2007 Location: Lancashire Online Status: Points: 1613 |
Post Options
Thanks(0)
|
Hmmmm, there is a grommet where your engine harness goes through the bulkhead, use that?
As for routing, straight down the sides where the wiring loom goes would be best |
|
FireStorm
NPOC Guest Joined: 24 Apr 2007 Location: Essex Online Status: Points: 2337 |
Post Options
Thanks(0)
|
As above.....done it 2 many times! passenger side is easiest.
|
|
None
|
|
Danny01204
NPOC Guest Joined: 05 Jun 2008 Location: Lancashire Online Status: Points: 68 |
Post Options
Thanks(0)
|
Ive dne mine matey. Passenger side, grommet. Punch a hole in this, or snip one in it with wire cutters. Then feed ur power and remote on cable down the passenger side sills. If you look where the door sills are, the grey plastic trim just lifts up (its clipped on with plastic clips). Then feed the wires under your rear seats, they just lift forwards on a pivot. Do your left and right audio cables, but run them up the other side of the car to reduce interferance from the power cables.
|
|
If it doesnt taste of something you know....it Tastes like Chicken!
|
|
essNchill
Admin Group Nissyen Gaius Fluff Joined: 05 Feb 2003 Location: Hampshire Online Status: Points: 62606 |
Post Options
Thanks(0)
|
The gromit you'll be looking for is directly below the fuel filter.. So start at the top of the engine bay (right hand side) and on the bulkhead, look for the shiny cylindrical fuel filter, then on that line heading down towards the floor, you'll see a big black rubber gromit, go through that.
I'll try and dig you out a piccy for ease and reference
|
|
bandit_senior
NPOC Guest Joined: 16 Jun 2008 Location: Lancashire Online Status: Points: 85 |
Post Options
Thanks(0)
|
Thank you very much guys was after some similar info myself!
|
|
essNchill
Admin Group Nissyen Gaius Fluff Joined: 05 Feb 2003 Location: Hampshire Online Status: Points: 62606 |
Post Options
Thanks(0)
|
I can't find any good reference photos, so just went outside and took some meself... I can't get these up until I unite my moby with my lead.. Which will be when I get home from work in the morning
|
|
jonnyw
NPOC Guest Joined: 11 Oct 2008 Location: Lancashire Online Status: Points: 56 |
Post Options
Thanks(0)
|
Cool, thanks for the replies.
Pics will definitely be useful if it's not too much trouble.
My new head unit is due for delivery today, which I'm gonna fit this evening (am currenlty running the OEM tape player), then fingers crossed if I have time, I'll look at running the cables too :)
(Just glad I don't have to do any more drilling)
|
|
Nissan Primera P11/144 Sport
|
|
essNchill
Admin Group Nissyen Gaius Fluff Joined: 05 Feb 2003 Location: Hampshire Online Status: Points: 62606 |
Post Options
Thanks(0)
|
Here you go... The piccies from last night..
1st up, here's the fuel filter at the top of the engine bay (RHS)
Another pic of the filter (closer in) and now you can see my amp power cable etc
These piccies are taken from underneath the fuel filter and are a close up on the rubber gromit and show the power cable going through:
Now some others have used a different gromit, (as mentioned above ).. It has some wiring going through it and here's a photo of that gromit (on another P11), although I am unsure of it's exact location.. It is in the rough same area as the where I have used however:
Both these gromits will drop the wire through into the passenger foot well area.. From there, just run the cable under the placcy channel / side sills, inside the car (passenger side).
Hope that helps and good luck,
Shaun
PS - Off to bed at last
|
|
jonnyw
NPOC Guest Joined: 11 Oct 2008 Location: Lancashire Online Status: Points: 56 |
Post Options
Thanks(0)
|
Thanks so much for the advice everyone, and thank you so much for going to the effort of taking and posting pics Shaun :)
I fitted the new HU this evening, and am really impressed. Now I just need to get the chance to install the rest. Thanks again everyone - will let you know how it goes :) |
|
Nissan Primera P11/144 Sport
|
|
Post Reply | Page 12> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |